flexfactory anyfeed SX Series User Manual

flexfactory ag Quick Setup Guide and User’s anyfeed SX Series 4
Figure 6-2 Retainer ................................................................................................................... 42
Figure 6-1 Feed deck beneath the feed surface (no backlight shown) .................................... 42
Figure 6-3 Screws on bulk container ........................................................................................ 43
Figure 6-4 Feed deck ................................................................................................................ 43
Figure 6-5 Screw to set retainer speed .................................................................................... 43
Figure 6-6 Feeder back plate .................................................................................................... 43
Figure 6-7 Valve block .............................................................................................................. 43
Figure 7-1 Face plate of the feeder .......................................................................................... 44
Figure 7-2 Dismount the bunker .............................................................................................. 44
Figure 7-3 Pneumatic line ......................................................................................................... 45
Figure 7-4 Dismantle the side panels and the V-rails............................................................... 45
Figure 7-5 Dismantle the backlight .......................................................................................... 45
Figure 7-6 FOV support plate and screws ................................................................................ 46
Figure 7-7 Feeder before installing the FOV support plate ..................................................... 46
Figure 7-8 Slide in the FOV support plate ................................................................................ 46
Figure 7-9 Tighten down the FOV support plate ...................................................................... 46
Figure 7-10 Install the backlight ............................................................................................... 47
Figure 7-11 Mount the V-rails and the side panels .................................................................. 47
Figure 7-12 Mount the bunker and connect the pneumatic line ............................................ 47
Figure 8-1 Backlight G1 with cable ......................................................................................... 48
Figure 8-2 Backlight G2 with cable and LED controller ............................................................ 48
Figure 8-3 Feed platform and front cover ................................................................................ 49
Figure 8-4 Preparing the backlight ........................................................................................... 50
Figure 8-5 Inserting the backlight into the feeder ................................................................... 50
Figure 8-6 Positioning the backlight ......................................................................................... 50
Figure 8-7 Installing the backlight screws ................................................................................ 50
Figure 8-8 Inserting the backlight ............................................................................................ 51
Figure 8-9 Install the backlight screws ..................................................................................... 51

flexfactory anyfeed SX Series Specifications

General

Brand	flexfactory
Model	anyfeed SX Series
Category	Industrial Equipment
Language	English