flexfactory anyfeed SX Series User Manual

flexfactory ag Quick Setup Guide and User’s anyfeed SX Series 36
5 OPERATION WITH PARALLEL COMMUNICATIONS
5.1 PREPARING THE FEEDER FOR PARALLEL COMMUNICATIONS
The anyfeed SX default settings are configured for the use with serial communications. To
operate the feeder using parallel communications, the following steps are necessary:
1. Make sure no cables are connected to the feeder. Then, dismantle the Interface
panel by removing the four screws as shown below.
Figure 5-1 Removing the Front Interface Panel
Do not disconnect the cables connected on the inside of the
Interface panel.

flexfactory anyfeed SX Series Specifications

General

Brand	flexfactory
Model	anyfeed SX Series
Category	Industrial Equipment
Language	English