flexfactory anyfeed SX Series User Manual

flexfactory ag Quick Setup Guide and User’s anyfeed SX Series 7
1 OVERVIEW
1.1 INTRODUCTION
This manual describes the key points for getting your anyfeed SX operational. Before getting
started, make sure you have all the components necessary to set up your feeder. In addition
to the feeder (shown in Figure 1-1 below), it is assumed that you have a robot and vision
system to work with the feeder.
You must have read and fully anderstood this manual before proceeding with the installation
and operation of the anyfeed SX.
Figure 1-1 anyfeed SX 240
1.2 TECHNICAL SPECIFICATIONS
SX 240
SX 160
Dimensions
see page 15
see page 16
Weight
70 kg
67 kg
Air requirements
5–6 bar unlubricated filtered air
5–6 bar unlubricated filtered air
Electrical requirements
24 VDC / 10 A
24 VDC / 10 A
Ambient Temperature
5 – 40 °C
5 – 40 °C
Humidity
5 – 90 % (no condensation)
5 – 90 % (no condensation)
Table 1-1 Technical Specifications

flexfactory anyfeed SX Series Specifications

General

Brand	flexfactory
Model	anyfeed SX Series
Category	Industrial Equipment
Language	English