flexfactory anyfeed SX Series - Material Checklist; Figure 2-3 Handles for Lifting and Positioning; Figure 2-4 Anyfeed SX Feeder

flexfactory ag Quick Setup Guide and User’s anyfeed SX Series 13
Warning
Only use handles to lift and move the feeder.
2 persons are needed to lift the feeder.
Figure 2-3 Handles for lifting and positioning
 Place the feeder on a prepared base
 at least 650 mm of the feeder’s base housing must rest on the base plate
2.3 MATERIAL CHECKLIST
At minimum, you should have received the following material:
FEEDER
anyfeed SX series feeder
Figure 2-4 anyfeed SX feeder