flexfactory anyfeed SX Series - Page 3

flexfactory ag Quick Setup Guide and User’s anyfeed SX Series 2
3.4.2 Parallel I/O Cable ................................................................................................ 23
3.5 Testing the Installation .............................................................................................. 24
4 Operation with Serial Communications ........................................................................... 28
4.1 Program Flow ............................................................................................................. 28
4.2 Setting the Serial Communications Parameters ........................................................ 28
4.3 Serial Command Codes .............................................................................................. 29
4.3.1 Sending Commands to the anyfeed SX .............................................................. 29
4.3.2 Anyfeed SX Responses........................................................................................ 33
4.3.3 Command Parameters Default Values ............................................................... 35
5 Operation with Parallel Communications ........................................................................ 36
5.1 Preparing the feeder for parallel communications ................................................... 36
5.2 Parallel I/O Wiring Assignments ................................................................................ 39
5.3 Signal Handshake ....................................................................................................... 40
6 Maintenance and Settings................................................................................................ 41
6.1 Periodic maintenance ................................................................................................ 41
6.2 Removing and Installing the feed surface ................................................................. 41
6.3 Retainer Speed Settings ............................................................................................. 42
7 FOV Support Plate ............................................................................................................ 44
8 Backlight ........................................................................................................................... 48
8.1 Backlight Versions ...................................................................................................... 48
8.2 Preparing the INstallation .......................................................................................... 49
8.3 Installing the Backlight G1 ......................................................................................... 50
8.4 Installieren des Backlight G2 ..................................................................................... 51
8.5 Installing the LED Controller ...................................................................................... 52
8.6 LED-Controller/ Backlight Settings ............................................................................ 54
8.7 Function Check .......................................................................................................... 58
8.8 Configuring the LED Controller .................................................................................. 59