Fluke 5500A - Page 113

Maintenance
Complete List of Error Messages
4
4-17
545 (DDE: ) Can’t edit now
546 (DDE: ) Can’t set trigger to that now
547 (DDE: ) Can’t set output imp. now
548 (DDE:FR ) Compensation is now OFF
549 (DDE: ) Period must be >= 0
550 (DDE: ) A report is already printing
551 (DDE: ) -SC option not installed
600 (DDE:FR D) Outguard watchdog timeout
601 (DDE: ) Power-up RAM test failed
602 (DDE:FR ) Power-up GPIB test failed
700 (DDE: R ) Saving to NV memory failed
701 (DDE: R ) NV memory invalid
702 (DDE: R ) NV invalid so default loaded
703 (DDE: R ) NV obsolete so default loaded
800 (DDE:FR ) Serial parity error %s [%s is serial port]
801 (DDE:FR ) Serial framing error %s [%s is serial port]
802 (DDE:FR ) Serial overrun error %s [%s is serial port]
803 (DDE:FR ) Serial characters dropped %s [%s is serial port]
900 (DDE:FR ) Report timeout - aborted
1000 (DDE:FR ) Sequence failed during diag
1001 (DDE:FR ) Guard xing link diag fail
1002 (DDE:FR ) Inguard bus r/w diag fail
1003 (DDE:FR ) A6 A/D comm fault
1004 (DDE:FR ) A6 A/D or DAC fault
1005 (DDE:FR ) A6 DAC fine channel fault
1006 -1091 See “Diagnostic Error Messages”
1200 (DDE:FR ) Sequence name too long
1201 (DDE:FR ) Sequence RAM table full
1202 (DDE:FR ) Sequence name table full
1300 (CME: R ) Bad syntax
1301 (CME: R ) Unknown command
1302 (CME: R ) Bad parameter count
1303 (CME: R ) Bad keyword
1304 (CME: R ) Bad parameter type
1305 (CME: R ) Bad parameter unit
1306 (EXE: R ) Bad parameter value
1307 (QYE: R ) 488.2 I/O deadlock
1308 (QYE: R ) 488.2 interrupted query
1309 (QYE: R ) 488.2 unterminated command
1310 (QYE: R ) 488.2 query after indefinite response
1311 (DDE: R ) Invalid from GPIB interface
1312 (DDE: R ) Invalid from serial interface
1313 (DDE: R ) Service only
1314 (EXE: R ) Parameter too long
1315 (CME: R ) Invalid device trigger
1316 (EXE: R ) Device trigger recursion
1317 (CME: R ) Serial buffer full
1318 (EXE: R ) Bad number
1319 (EXE: R ) Service command failed
1320 (CME: R ) Bad binary number
1321 (CME: R ) Bad binary block
1322 (CME: R ) Bad character
1323 (CME: R ) Bad decimal number
1324 (CME: R ) Exponent magnitude too large