SC300 Option
Introduction
6
6-67
6-83. Introduction
This chapter contains the following information and service procedures for the
SC300 Oscilloscope Calibration Option functions.
• Specifications
• Theory of Operation
• Calibration Procedures
• Verification Procedures
• Hardware Adjustments made after Repair
The calibration and verification procedures provide traceable results for all of the SC300
functions as long as they are performed using the recommended equipment. All of the
required equipment along with the minimum specifications, are provided in Table 6-41
under “Equipment Required for Calibration and Verification.”
The calibration and verification procedures in this chapter are not the ones Fluke uses at
the factory. These procedures have been developed to provide you with the ability to
calibrate and verify the SC300 at your own site if necessary. You should review all of
the procedures in advance to make sure you have the resources to complete them. It is
strongly recommended that, if possible, you return your unit to Fluke for calibration and
verification.
Hardware adjustments that are made after repair, at the factory or designated Fluke
service centers, are provided in detail.
6-84. Maintenance
There are no maintenance techniques or diagnostic remote commands for the SC300 that
are available to users. If your SC300 is not installed or not receiving power, the
following error message appears on the display when you press
ato access the
oscilloscope calibration menus.
om030i.eps
If this message is displayed, and you have the SC300 installed in your Calibrator
Mainframe, you must return the Calibrator Mainframe to Fluke for repair. If you wish to
purchase the SC300, contact your Fluke sales representative.
To Next Page
Loading...
