Fluke 5700A Series II - IEEE-488 Interface Configuration

5700A/5720A Series II
Operators Manual
5-54
5-39. IEEE-488 Interface Configuration
The calibrator’s IEEE-488 interface supports the IEEE-488 interface function subsets
listed in Table 5-7.
Table 5-7. Supported IEEE-488 Interface Function Subsets
Interface Function Description
SH1 Complete source handshake capability
AH1 Complete acceptor handshake capability
T6 Basic talker; serial poll; no talk-only mode; unaddress if MLA
TEO No extended talker capabilities
L4 Basic listener operation; no listen-only mode; unaddress if MTA
LEO No extended listener capabilities
SR1 Full service request capability with ability to bit-mask SRQ
RL1 Full remoter/local capability including local lockout
PPO No parallel poll capability
DC1 Device clear capability
DT0 No device trigger capability
C0 No bus control capability