Fluke 5700A Series II User Manual

Features
Introduction 3
3-3
3-1. Introduction
This chapter is a reference for the functions and locations of the calibrator's front and rear
panel features, and provides brief but thorough descriptions of each features, for quick
access. Please read this information before operating the calibrator. Front panel operating
instructions for the calibrator are provided in Chapter 4, and remote operating
instructions are provided in Chapter 5.
3-2. Front Panel Features
Front panel features (including all controls, displays, indicators, and terminals) are shown
in Figure 3-1. Each front panel feature is briefly described in Table 3-1.
3-3. Display Screen Saver
The Control Display (described in Table 3-1) is equipped with a screen saver that
lengthens the display’s life when the front panel is not being used. The display becomes
blank after 30 minutes of inactivity, unless it is one of the operating states that override
the screen saver.
If the screen saver is in effect, you can restore the display by pressing C. Pressing
another key, or turning the knob, will also restore the display in addition to performing
the command selected by the key or knob.
The screen saver will not go into effect after 30 minutes of inactivity if:
• the Setup Menu or any of its submenus are displayed
• the calibrator is being operated under remote control
• the calibrator is undergoing calibration or diagnostics
• an error message is displayed

Fluke 5700A Series II Specifications

General

Type	Multifunction Calibrator
Operating Temperature	0 °C to 50 °C
Storage Temperature	-20 °C to 70 °C
Voltage Range	0 to 1100 V
DC Voltage Range	10 μV to 1100 V
Frequency Range	1 MHz
Humidity	non-condensing
Power Requirements	100 V to 240 V