5700A/5720A Series II
Operators Manual
6-6
15. Enter the decimal code of the ASCII character(s) designated as EOF. (Appendix C
contains a table of ASCII codes.) Verify that your selection is correct as shown on
the display.
16. To exit the setup menus, press P five times.
6-4. Printing Calibration Reports
Calibration reports are available for calibration check and calibration. The following
paragraphs describe what you can print and how to do it.
Note
Reports can only be printed through the serial port when it is not being
used as the remote control port. (They can be printed through the IEEE-488
port.)
6-5. Calibration Shift Results
The Calibration Shift Results printout presents all adjustments made to stored zero-offset
and gain constants, as a result of any drift detected at the most recent calibration. The
printout contains the following information:
• Heading containing the date, time, and user report string
• Modules present (installed or attached)
• Most recent calibration dates and temperatures
• Space for recording information about external standards used
• Values of externally calibrated internal references
• DC voltage output shifts for each range
• AC voltage output shifts for each range
• Current output shifts for each range (ac and dc)
• Resistance shifts for each value
• 5725A Amplifier output shifts (if attached)
• Wideband AC Module (Option 5700A-03) output shifts (if installed)
To Next Page
Loading...
