Fluke 5700A Series II - 7-1. Introduction

Operator Maintenance
Introduction 7
7-3
7-1. Introduction
This chapter explains how to perform the routine maintenance and calibration tasks
required to keep your calibrator in optimal operating condition. The tasks covered in this
chapter include the following.
• Replacing the fuse
• Cleaning the air filter and external surfaces
• Calibrating to external standards
• Calibrating the range
• Calibrating the wideband ac module
• Checking the calibration
For intensive maintenance tasks such as troubleshooting or repair, and for all procedures
that require opening the cover of the instrument, refer to the 5700A/5720A Series II
Service Manual. The service manual contains complete verification procedures for
checking that traceability to national standards is being maintained by the normal
calibration procedure.