Fluke 5700A Series II User Manual

Appendices
Fault Codes
A
A-11
2579 Could not Cal 19 Ohm (Meas 1)
2580 Could not Cal 19 Ohm (Meas 2)
2581 Could not Ext Cal 1 Ohm (0.26V CM Meas)
2582 Could not Ext Cal 1 Ohm (Ext Meas)
2583 Could not Ext Cal 1 Ohm (0.13V CM Meas)
2584 Could not Ext Cal 1 Ohm (Int Meas)
2585 Could not Ext Cal 1.9 Ohm (0.18V CM Meas)
2586 Could not Ext Cal 1.9 Ohm (0.12V CM Meas)
2587 Could not Ext Cal 1.9 Ohm (Int Meas)
2588 Could not Cal Wideband Gain
2589 Bad Cal Step Selector
2590 A/D Appears To Have Failed
2591 User Range Gain Adjustment Is 0
2592 Stored User Range Gain Adjust Is 0
2593 220 µA AC Flatness Calibration Failed
2594 2.2 mA AC Flatness Calibration Failed
2595 22 mA AC Flatness Calibration Failed
2596 220 mA AC Flatness Calibration Failed
2597 Bad Range Number For IAC Flatness Cal
2598 No Data For DCI Calibration
2599 2.2V AC Flat Early Fail
2600 2.2V AC Flat Bad AC Cal Sensor?
2601 2.2V AC Flat Diverge
2602 22V AC Flat Early Fail
2603 22V AC Flat Bad AC Cal Sensor?
2604 22V AC Flat Diverge
2605 220V AC Flat Early Fail
2606 220V AC Flat Bad AC Cal Sensor?
2607 220V AC Flat Diverge
2608 1100V AC Flat Early Fail
2609 1100V AC Flat Bad AC Cal Sensor?
2610 1100V AC Flat Diverge
2611 220 µA IAC Flat Early Fail

Fluke 5700A Series II Specifications

General

Type	Multifunction Calibrator
Operating Temperature	0 °C to 50 °C
Storage Temperature	-20 °C to 70 °C
Voltage Range	0 to 1100 V
DC Voltage Range	10 μV to 1100 V
Frequency Range	1 MHz
Humidity	non-condensing
Power Requirements	100 V to 240 V