Fluke 5700A Series II - Page 293

Appendices
Fault Codes
A
A-21
3826 A8: 8255 Was Reset
3827 Assembly A8 Too Hot
3900-Level Faults: Self Diagnostics Subsystem (Wideband)
3900 A5: 8255 Control Word
3901 A5: 8255 Port A Fault
3902 A5: 8255 Port B Fault
3903 A5: 8255 Port C Fault
3904 Optional Assemblies A5/A6 Are Missing
3905 A6: Phase Lock Loop Fault
3906 A6: Phase Lock Loop Fault At 30Mhz
3907 A5: RMS Sensor Fault
3908 A5: RMS Sensor Fault At 30Mhz
3909 A5: RMS Sensor Fault At 6.5V DC in
3910 A5/A6: Ampl. Control Fault
3911 A5/A6: Ampl. Control Fault At 30Mhz
3912 A5/A6: Output Offset Fault
3913 A5/A6: Output Offset Fault At 30Mhz
3914 A5: 0DB Output Attenuation Fault
3915 A5: 10DB Output Attenuation Fault
3916 A5: 20DB Output Attenuation Fault
3917 A5: 30DB Output Attenuation Fault
3918 A5: 40DB Output Attenuation Fault
3922 A5/A6: Wideband Initialization Fault
3923 A5: 8255 Was Reset
4000-Level Faults: Analog Sequencing Subsystem
4000 Bad Sequence ID
4001 Over Nested Subsequences
4002 Bad Sequence Command Code
4003 Bad Reply Size From Inguard
4004 Reply From Inguard Too Small
4005 False MSG Semaphore from Inguard
4006 Inguard CPU POP