Features
Rear Panel Features 3
3-13
Table 3-2. Rear Panel Features (continued)
F
IEEE-488 Connector
A standard interface connector for operating the calibrator in remote control
as a Talker or Listener on the IEEE-488 Bus. Refer to Chapter 5 for bus
connection and remote programming instructions.
G
CALIBRATION Switch
A slide switch that write enables and disables the nonvolatile memory that
stores calibration constants, dates, and setup parameter settings.
Switching to ENABLE write enables the memory, and switching to
NORMAL protects data in memory from being overwritten. The switch must
be in the ENABLE position to set the clock. The switch is recessed to allow
the metrologist to cover it with a calibration sticker to guarantee calibrator
integrity.
H
RS 232C Connector
A male (DTE) serial port connector for transmitting internal calibration
constant data to a printer, monitor, or host computer, and for remote control
of the calibrator. Chapter 6 describes proper cabling, how to set up the
serial interface, and how to transmit data from the calibrator. Chapter 5
describes how to use the serial interface for remote control.
5
1 2 3 4
678
Figure 3-2. Rear Panel Features
To Next Page
Loading...
