Contents
ix
Autotest Results for Loopback Mode ......................278
Autotest in Far End Source Mode ..................................280
Auto Wavelength Modes .........................................280
Step 1: Set the Reference in
Far End Source Mode ...............................................282
Step 2: Measure the Loss of the Test
Reference Cord You Will Add ..................................286
Step 3: Do an Autotest in
Far End Source Mode ...............................................287
Autotest Results for Far End Source Mode .............288
Bi-directional Tests ..........................................................290
How to Use the Talk Function ........................................293
Chapter 10 The Power Meter and Light Source
How to Monitor Power and Loss ...................................295
How to Control the Light Source ...................................299
Use the Display to Control the
Main Tester’s Light Source .......................................300
Use the Module’s Button to Control
the Light Source .......................................................300
Chapter 11 The OptiFiber Pro OTDR Module
Overview of the OTDR Module ......................................303
OptiFiber Pro Connectors, Keys, and LEDs ....................304
How to Remove and Install the Connector
Adapters ..........................................................................307
The Home Screen for OptiFiber Pro Modules ...............308
Settings for OTDR Tests ..................................................310
OTDR Settings for Limits that
Calculate a Loss Limit ......................................................319
About Launch and Tail Cords .........................................320
To Next Page
Loading...
