Fluke Versiv Series - How to Quickly Try Different OTDR Settings

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
366
How to Quickly Try Different OTDR Settings
After an OTDR test, you can quickly change some OTDR settings
when you want to try different settings on the same fiber. After
you do a test, tap SETUP on the TRACE screen, then select settings
on the MANUAL OTDR screen (Figure 150).
You can save your settings to the Active test setup or to a New
test setup, or you can tap TEST to do a test without saving the
settings.
GPU220.EPS
Figure 150. Manual OTDR Screen for Quick Changes to Test Settings
A
C D
E
B