Fluke Versiv Series - To Make a Cable ID Set for Tests on Fiber Cabling

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
524
To make a cable ID set for tests on fiber cabling
4-4. On PROJECT screen, tap NEW ID SET.
4-5. For this tutorial, you will make an ID set that has 10 IDs for 5
duplex fiber links:
a. On the CABLE ID SETUP screen (Figure 198 on page 526),
tap the box under First ID, use the keyboard to enter 1A.
b. Tap the box under Last ID, use the keyboard to enter 5B,
then tap DONE.
c. Under Select Media, tap Fiber. The screen shows the tests
you can do with the OptiFiber Pro and CertiFiber Pro
modules. The tester uses these settings to calculate how
many tests you have completed in the project.
d. Tap End 1 and End 2 for the OTDR test and tap the Loss/
Length test.
Note
You can use ID sets you make for fiber media only
when you do tests on fiber cabling.
e. Tap REVIEW. The CABLE ID REVIEW screen shows the ID
set, the total number of IDs, and the tests you specified
for the ID set.
4-6. To save the ID set, tap SAVE on the CABLE ID REVIEW screen.
4-7. On the PROJECT screen, delete the default ID set Next ID:
001.