Fluke Versiv Series - Step 1: Give the Project a Name; Step 2: Specify an Operator

Chapter 17: Use Projects
Tutorial: Make a New Project
519
LinkWare Live will not use organization or subproject names you
create on the tester. If you use the format “Organization
Name>>Project Name>>Subproject Name” to enter names on the
tester, then sync the project to LinkWare Live, LinkWare Live will
use all of the names as the project name.
Step 1: Give the Project a Name
1-1 On the home screen, tap the PROJECT panel. The PROJECT
screen shows the active project.
1-2. Tap CHANGE PROJECT, then tap NEW PROJECT.
1-3. Use the keyboard to enter a name for the project, then tap
DONE.
Step 2: Specify an Operator
The operator is the person who will use the project to do a job.
2-1 On the PROJECT screen, tap the Operator panel, then select
or add an operator:
 To select a different operator, then tap a name in the
OPERATOR list.
 To add an operator to the list, tap NEW OPERATOR, use
the keyboard to enter a name.
2-2. Optional: Enter the email address that the operator will use
as an ID to sign in to LinkWare Live.
2-3. When you are finished, tap DONE.
2-4. To go back to the PROJECT screen, tap the name of the
operator you want to use.