Fluke Versiv Series - Settings for the Wired Port; Wi-Fi Settings; Regulatory Information for the Wi-Fi Radio; Delete Wi-Fi Settings and Passwords

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
564
Settings for the Wired Port
The tester can use DHCP (dynamic host configuration protocol) or
Static for the address method. Most networks use DHCP.
For Static, enter an IP address for the tester and the Subnet Mask,
Gateway address, and DNS1 and DNS2 addresses for the network.
If you are not sure what to enter, speak to the network
administrator.
Wi-Fi Settings
Table 21 shows the Wi-Fi settings.
Regulatory Information for the Wi-Fi Radio
To see the regulatory information
On the home screen, tap TOOLS, then tap Regulatory
Information.
Delete Wi-Fi Settings and Passwords
The tester saves the security settings and passwords for the Wi-Fi
connections you use.
To delete all Wi-Fi settings and passwords
On the home screen, tap TOOLS, tap Network, tap the Wi-Fi
panel, then tap FORGET ALL.