Fluke Versiv Series - Modified 1 Jumper Reference

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
650
Modified 1 Jumper Reference
This section shows modified reference and test connections that
give 1 jumper results. Use these connections if you need 1 jumper
results, but do not have the correct connector adapters to connect
the CertiFiber Pro modules’ output ports to the link. This method
lets you keep the test reference cords connected to the module’s
output ports when you connect the modules to the link.
Figure C-4 shows reference and test connections for a fiber with
MT-RJ connectors.
On the tester select 1 Jumper as the Reference Method when using
modified 1 Jumper connections.