Fluke Versiv Series - Do the Smartloop Test

Versiv Series Cabling Certification Product Family
Technical Reference Handbook
380
Do the SmartLoop Test
1 Make the connections shown in Figure 155.
2 On the home screen, make sure the IDs for the fibers are
correct. The tester uses the Fiber A ID for the fiber connected
to the launch cord.
3 Tap TEST or press .
Note
If the tester shows a message about the connection
quality of the OTDR port, but the OTDR connection
on the tester is good, inspect the ends of the
loopback cord. See “Port Connection Quality for
SmartLoop Tests” on page 332.