Chapter 17: Use Projects
How to Change Settings as You Use a Project
545
2 On the EDIT CABLE IDs screen, or the IMPORTED IDs screen
(for ID sets downloaded from LinkWare PC or LinkWare Live),
select the test under Select Fiber Tests.
3 Tap SAVE, then tap DONE, or for IMPORTED IDs, tap DONE
then tap DONE again.
To Change the Project
To save results in a different or new project, press home, tap the
project panel, then tap CHANGE PROJECT. Select a different
project, or tap NEW PROJECT to start a new project. See Figure
205 on page 546.
These projects are only on the tester. They have not been
synced to LinkWare Live. The % exported value shows the
percentage of the results that has been exported to a USB flash
drive.
These projects have been synced to the LinkWare Live
organization shown (“QuickCable” in this example). The %
exported value shows the percentage of the results that has
been exported to LinkWare Live.
The cloud and “+” icon shows that the project is on the
tester and in LinkWare Live.
Note
When the tester is signed in to LinkWare Live, this
screen does not show projects that are only in
LinkWare Live. To see those projects, tap
TRANSFER, then tap the LinkWare Live panel.
Tap NEW PROJECT to create a new project.
TRANSFER lets you sync projects with LinkWare Live, export or
import results to or from a flash drive, and delete results on the
flash drive. The TRANSFER function also lets you sync project
setups and results with LinkWare Live.
To Next Page
Loading...
