Versiv Series Cabling Certification Product Family
Technical Reference Handbook
270
fiber fails, the direction does not tell you the
location of the problem.
Fiber IDs for Saved Results in Smart Remote Mode
If Auto Save is On and the test passed, the tester saves two
records, one for each fiber. The records have the next two IDs in
the ID list or sequence.
If your IDs are from a list, and you use the last ID in the list, the
tester does not automatically save subsequent results. You must
tap SAVE then enter one or both IDs to save the results.
How to Change Fiber IDs Before You Do Tests
Tap the Next ID panel on the home screen. On the CHANGE ID
screen (Figure 114 on page 271), tap the Input Fiber ID, then enter
a new ID. The tester automatically sets the Output Fiber ID to the
next ID in the list or sequence.
How To Save Results with Non-Consecutive IDs
Set Auto Save to Off before you do the test. Then, on the SAVE
RESULT screen, tap the Input Fiber ID or Output Fiber ID window
to change the ID. For subsequent IDs, the tester uses the IDs that
follow the Output Fiber ID you used.
How to Swap the Input and Output IDs
On the CHANGE ID and SAVE RESULT screens, you can tap to
swap the input and output IDs. The tester uses subsequent IDs
from the list or sequence in descending order.
Figure 115 shows unsaved and saved results for bi-directional and
uni-directional results.
To Next Page
Loading...
