Chapter 1: Get Acquainted
WSafety Information
11
Do not connect APC (angled physical contact)
connectors to the output or input ports. An APC
connector can damage the UPC fiber endface in the
ports.
To make sure your test results are as accurate as
possible, do the reference procedure frequently. See
“About the Reference for Fiber Tests” on page 245.
Use only high-quality test reference cords that
comply with the standards. See “About Test
Reference Cords and Mandrels” on page 247
For OptiFiber Pro OTDR Modules
WWarning: Class 1 and Class 2 Laser Products
*
To prevent possible eye damage caused by
hazardous radiation:
Do not look directly into optical connectors. Some
optical equipment emits invisible radiation that can
cause permanent damage to your eyes.
Do not do any tests that activate the outputs on the
tester unless a fiber is attached to the output.
When you inspect fiber endfaces, use only
magnification devices that have the correct filters.
Use the Product only as specified or hazardous laser
radiation exposure can occur.
To Next Page
Loading...
