Fluke Versiv Series - Tutorial: How to Use a Project for Tests with Optifiber Pro and Certifiber Pro Modules

Chapter 17: Use Projects
Tutorial: How to Use a Project for Tests with OptiFiber Pro and CertiFiber Pro
535
Tutorial: How to Use a Project for Tests with
OptiFiber Pro and CertiFiber Pro Modules
This tutorial assumes that you completed the tutorial “Make a
New Project” on page 516.
In this tutorial, you will do OTDR tests on both fibers of a duplex
fiber link, then you will add loss/length results to the OTDR results
for the two fibers.
Figures 202 and 203 show the equipment necessary for this
tutorial.
Note
Select launch/tail cords and test reference cords
that have the correct connectors to connect to the
OptiFiber Pro and CertiFiber Pro modules and to
the fiber link or segment.
Figure 202. Equipment for the OTDR Project Tutorial
GPU159.EPS
 Main tester with OptiFiber
Pro module installed
 Launch and tail cords (match
the fiber to be tested)
 FI-1000 video probe and fiber
cleaning supplies
 AC adapter with line cord (optional)
 Duplex fiber link or segment
A
B
D
C
E
Fiber 1A
Fiber 1B
Fiber 1A
Fiber 1B
End 1
End 2