Versiv Series Cabling Certification Product Family
Technical Reference Handbook
404
SET COMP: Lets you select a launch method and set the
lengths of launch and tail cords. See“About Launch and Tail
Cords for OSP Links” on page 416.
RESULTS: Tap RESULTS to see and manage the results that are
saved in the tester.
SYNC: To upload results to LinkWare Live, tap SYNC. See Chapter
18.
TEST: Tap TEST to do the test shown in the test setup panel.
The percentage of the tests in the project that are completed.
The tester uses the number of available IDs and the tests you
selected on the CABLE ID SETUP screen to calculate this
percentage. See Figure 198 on page 526. % Tested does not
show if your project contains only a Next ID list. See “To Make
ID Sets with International Characters” on page 550 for more
information about the Next ID list.
The type of module attached to the tester.
The asset management icon shows when the owner of a
LinkWare Live account has enabled the asset management
service for the tester. See “About the Asset Management
Service” on page 566.
About PON OTDR Tests
The HDR OTDR’s Auto PON OTDR and Manual PON OTDR tests
have the same settings and results as its Auto OTDR and Manual
OTDR tests, with an additional feature: The PON OTDR tests can
identify splitters. The Auto PON OTDR identifies splitters
automatically. The Manual PON OTDR test lets you use the
SPLITTER SETUP screen in the Manual PON OTDR Settings to
specify the split ratios for known splitters on a link. Or, you can
use the DISCOVER function to locate splitters and identify their
ratios.
To Next Page
Loading...
