Chapter 1: Get Acquainted
The HOME Screen
25
The HOME Screen
The HOME screen (Figure 6) shows important test settings. Before
you do a test, make sure these settings are correct.
For a home screen with a DSX CableAnalyzer module installed,
see Figure 26 on page 78.
For a home screen with a CertiFiber Pro module installed, see
Figure 105 on page 241.
For a home screen with an OptiFiber Pro module installed, see
Figure 130 on page 308.
PROJECT: The project contains the settings for a job and helps
you monitor the status of a job. When you save test results, the
tester puts them in the project. Tap the PROJECT panel to edit
the project settings, select a different project, or make a new
project.
Shows a summary of the test results in the project:
: The number of tests that passed.
: The number of tests that failed.
The number of results from tests on twisted pair cable that
have PASS* results. PASS* results have measurements within
the range of accuracy uncertainty for the tester. See “PASS*/
FAIL* Results” on page 98.
The test setup panel shows the settings the tester will use when
you tap TEST or press .
To change these settings, tap the panel, select the test on the
CHANGE TEST screen, tap EDIT, select different settings on the
TEST SETUP screen, then tap SAVE.
To Next Page
Loading...
