Chapter 19: Custom Media and Test Limits
Make a Custom Fiber Test Limit
577
Make a Custom Fiber Test Limit
Custom limits let you enter minimum and maximum values for
tests you do with CertiFiber Pro OLTS and OptiFiber Pro OTDR
modules and FiberInspector probes. This lets you use customer
requirements to pass or fail fiber links or components such as
patch cords and connectors. For OLTS tests, you can also select a
fixed loss budget or a loss budget that the tester calculates based
on the length of the link.
You can make up to 20 custom test limits for fiber cable. The
tester keeps custom limits with the other limits in the main tester
(not in the module). The names of custom limits have an asterisk
(*) at the start and end.
To make a custom fiber test limit
1 On the home screen, tap the test setup panel.
2 On the CHANGE TEST screen, tap a fiber test, then tap EDIT.
Note
You must select a test before you make a custom
test limit, but you can use the limit you make in
any test that has the fiber types that the limit
supports.
3 On the TEST SETUP screen, tap Test Limit, tap MORE, tap
Custom, then tap MANAGE.
4 On the MANAGE CUSTOM screen, tap the Create panel.
For a custom FiberInspector test, the USE DEFAULTS FROM
screen shows. Select Multimode or Singlemode
5 On the NEW CUSTOM LIMIT screen, tap Enter New Limit Name,
use the keyboard to enter a name, then tap DONE.
-continued-
To Next Page
Loading...
