Chapter 17: Use Projects
Tutorial: Make a New Project
525
GPU90.EPS
Figure 197. CHANGE CABLE IDs Screen
The screen shows the ID sets, copper or fiber, for the type of test
setup that shows on the home screen.
The ID set “001” is the default set the tester makes if no other ID
sets are in the project
To select an ID set, tap the ID set.
To add an ID set to the project, tap NEW ID SET.
To edit an ID set, tap the set, then tap EDIT.
To use the selected ID set, tap USE SELECTED.
C
D
E F
B
A
To Next Page
Loading...
