90
13 SETUP MENU
PARAMETER Description
Reverb Mix
+/- 50%
This boosts or cuts the Mix for all Reverb blocks in all presets. Note that this
offset is not reflected in the value shown for the actual Reverb Mix parameter.
This feature is provided because certain dead or lively performance spaces
may require more or less reverb across all presets.
Remember that Mix generally applies only to Reverb blocks which are wired in
series. Parallel reverbs typically require Mix to be at 100%.
Effects Mix
+/- 50%
This boosts or cuts the Mix of all blocks in which the Global Mix switch is set
to “ON”. This switch must be enabled on a per-block/per-preset basis and is
available on the Mix page of the Edit menu for the following blocks:
Chorus
Delay
Flanger
Formant
Multitap Delay
Phaser
Pitch
Plex Delay
Reverb
Ring Mod
Rotary
Ten-Tap Delay
This feature is provided because certain performance spaces may require more
or less of certain effects across all presets.
Noisegate Offset
+/- 40.00 dB
Globally raises or lowers the THRESHOLD of the Noise Gate for all Input blocks.
If the THRESHOLD for a given preset is set to “OFF”, the global Offset will have
no effect. See "The Fractal Audio Blocks Guide" for more on the noise gate.
Prompt on Edited Preset
Change
OFF/ON
When set to ON the unit will prompt before changing an edited preset. This may
save you from accidentally losing your edits. NOTE: Be sure to change this to
OFF before performing!
Indicate Edited on Scene
Change
OFF/ON
This determines whether or not the EDITED top panel LED (and corresponding
graphic in the editor) is triggered by Scene changes or not. Even if the LED is
disabled, the current scene will still be saved whenever you store a preset.
Display Offset
0, 1
(Also appears in the MIDI/Remote menu) Causes presets numbers to begin
at 001 instead of 000. This only offsets the display, meaning that it does not
change which preset is actually loaded by a given footswitch or MIDI message.
Default Scene
AS SAVED, SCENES 1–8
When set to “As Saved” the scene selected when recalling a preset is the scene
that was active when the preset was last saved. When set to a particular scene
value that scene will always be selected when any preset is recalled.
Tap Tempo
AVERAGE, LAST TWO
Determines how the tempo changes when tapping the front panel TEMPO
button or an external tap tempo controller (see p. 98). “AVERAGE” sets the
tempo based on the average of ten taps, meaning taps are more forgiving
but changes are more gradual. “LAST TWO” considers only the time interval
between the last two taps, which means taps must be more precise but
changes occur more quickly.
Value Knob Push Function By default, pushing the main “VALUE” knob shows the layout grid. To disable
this feature, change the setting of this parameter to “NONE”.
AC Line Frequency The Noise Gate in the Input Block uses smart EMI ltering to reduce hum and
buzz. For this to work correctly, you must set this parameter to match the power
line frequency of your country (i.e. 60 Hz for North America, 50 Hz for EU, etc.).
To Next Page
Loading...
