55
In the rst window, touch the „i“ key on the
„HEAD.INFO“ button to call up the orbital
welding gun data.
IMPORTANT! The elds contained in this
window are not controls and are for display
purposes only.
- Diameter min. - minimum diameter of the pipe joins to be welded [mm]
- Diameter max. - maximum diameter of the pipe joins to be welded [mm]
- Pulses
- Sync. switch - position in tenths of a degree of the synchronisation switch A value
of 0 means that no synchronisation switch is connected. A value of 3600 means, for
example, that the limit switch is tted at the 360 ° position
- Max. speed - highest rotation speed [cm/min]
- Speed adj. - correction factor for the rotation speed
OFF - no correction factor
- Wire - maximum wire feed speed [cm/min]
The illustration on the left shows the pin
assignment for the welding torch connec-
tion as seen from the front
The table illustrated below shows which
numbers the „torch plug“ eld contains
depending on the pin just activated. The
table also explains the meaning of the
number shown in the „torch plug“ eld for a
welding torch and an orbital welding gun.
1
2
3
4
5
6
7
8
9
Alarms and
device-specic
data
(continued)
Pin Indicator Welding torch Up/Down Orbital welding gun
2 4 Down -
2 5 - Remaining air alarm
3 8 Lower -
3 9 - External stop
4 2 Up -
5 16 Start -
5 17 - External start
8 1/0* Up/Down -
9 - GND GND
* The value becomes 0 when the Pin 8 - Pin 9 (=GND) contact is closed
- Welding torch Up/Down: contact closed
- Orbital welding gun: contact open
To Next Page
Loading...
