Connecting wire-feed unit to system components
Safety
WARNING!
An electric shock can be fatal.
Before starting the work described below:
▶
Turn the power source mains switch to the "O" position
▶
Disconnect the power source from the mains
▶
Ensure that the power source remains disconnected from the mains until all work
has been completed
CAUTION!
Risk of injury and damage from loose connections.
▶
All cables, leads and hosepacks must be properly secured, undamaged, insulated
and adequately dimensioned.
General
NOTE!
Also follow the instructions and information in the documents 42,0410,1946 and
42,0410,2010 when connecting the wirefeeder to the system components.
Connecting the
WF 15i/25i/30i R
PAP to the sys-
tem components
IMPORTANT! Whenever the torch hosepack is fitted or removed, ensure that the coup-
ling point is clean and dry. Remove any coolant that has escaped from the coupling
point.
1 2
106
To Next Page
Loading...
Need help?
General
