WF wire-feed unit
Device concept The robot wirefeeders of the WF 15i/25i/30i R and R PAP series have been specifically
designed for robot mounting.
The wirefeeders are available in several different versions:
WF 15i/25i/30i R:
For applications in which the hosepack is externally mounted on the robot.
WF 15i/25i/30i R PAP:
For applications in which the hosepack is mounted in the robot arm.
WF 25i R / L and 30i R / L:
For applications in which the torch hosepack is connected to the wirefeeder from the left.
Proper use The device is designed exclusively for wirefeeding in automated MIG/MAG welding
applications in conjunction with Fronius system components. Any use above and beyond
this purpose is deemed improper. The manufacturer shall not be held liable for any dam-
age arising from such usage.
Utilisation in accordance with the intended purpose also comprises:
- carefully reading these operating instructions
- following all the instructions and safety rules in these operating instructions
- performing all stipulated inspection and maintenance work
Safety
WARNING!
Danger due to incorrect operation and incorrectly performed work.
This can result in severe personal injury and damage to property.
▶
All the functions described may only be used by trained and qualified personnel.
▶
Fully read and understand this document.
▶
Fully read and understand all the Operating Instructions for the system components,
especially the safety rules.
31
EN
To Next Page
Loading...
Need help?
General
