Fronius TPS/i Push - Fitting the TpsI Torch Neck; Safety; Fitting the TpsI Torch Body - Standard; OPT I MHP Wirebrake Option

Fitting the TPS/i torch neck
Safety
CAUTION!
Risk of burns from hot torch body, hot torch body coupling and other hot welding
torch components.
Before starting work on the torch body, the torch body coupling and all other welding
torch components:
▶
Allow the torch body, torch body coupling and all other welding torch components to
cool down to room temperature (+25 °C, +77 °F)
▶
Wear electrically insulated and heat protective gloves
▶
Use a suitable tool
Fitting the TPS/i
torch body -
Standard
45,0200,1404
Special tool required
IMPORTANT! Whenever the welding torch is fitted or removed, ensure that the coupling
point is clean and dry. Remove any coolant that has escaped from the coupling point.
1
18 ± 2 Nm
13.28 ± 1.48 lb-ft
2
“OPT / i MHP
WireBrake”
option
If you would like to fit the “OPT / i MHP WireBrake” option, read the “Fitting the OPT / i
MHP WireBrake and torch body” chapter.
70