To Next Page

To Previous Page

- The wire electrode will be threaded 1 mm (0.039 in.) after the wire threading

button is pressed

- After a short pause, the wirefeeder continues to thread the wire electrode. If

the wire threading button remains pressed, the speed will increase every

second at a rate of 10 m/min (393.70 ipm) until the preset feeder inching

speed is reached

- If the wire electrode comes into contact with a ground earth connection, the

wirefeeding will be stopped and the wire electrode will be retracted again by

1 mm (0.039 in.)

Method 2

Threading the wire electrode in 1 mm increments (0.039 in. increments) – always

press the wire threading button for less than one second (tap)

If the wire electrode comes into contact with a ground earth connection, the

wirefeeding will be stopped and the wire electrode will be retracted again by

1 mm (0.039 in.).

NOTE!

If there is a ground earth connection with the contact tip before the wire threading

button is pressed, the wire electrode will be retracted when the button is pressed

until it is short-circuit-free – it retracts by no more than 10 mm (0.39 in.) with each

press of the button.

If there is still a ground earth connection with the contact tip after 10 mm (0.39 in.) of wire

retraction, pressing the wire threading button again will cause the wire electrode to be

retracted again by a maximum of 10 mm (0.39 in.). The process will be repeated until

there is no longer a ground earth connection with the contact tip.

Fronius TPS/i Push User Manual

Questions and Answers: