Fronius TPS/i Robotics PushPull CMT - Replacing the WF 25 I Robacta Drive Clamping Lever; Replacing the WF 60 I Robacta Drive CMT Clamping Lever

125
EN
4. Contact tips
– Worn-out (oval) wire entry and wire exit holes
– Heavily covered in welding spatter
– Fusion penetration on the tip of the contact tube
5. Gas nozzles
– Heavily covered in welding spatter
– Burned-off outside edges
– Notches
Replacing the WF
25i Robacta Drive
clamping lever
1 2
Replacing the WF
60i Robacta Drive
CMT clamping le-
ver
1 2
1
2
1
2