36
WF Robacta Drive
General
The WF 25i Robacta Drive and WF 60i Ro-
bacta Drive CMT are designed for gas or
water-cooled systems. The built-in motor
ensures precise wirefeeding (pull system).
The torch body is fitted to the Robacta Dri-
ve.
Warning notices
on the device
The device is fitted with safety symbols and a rating plate. The safety symbols and rating
plate must not be removed or painted over. The safety symbols warn against operating the
equipment incorrectly, as this may result in serious injury and damage.
WF 25i Robacta Drive rating plate WF 60i Robacta Drive CMT rating plate
Welding is dangerous. The following basic requirements must be met to ensure
the equipment is used properly:
- Anyone performing automated welding must be sufficiently qualified
- Suitable protective equipment must be used
- All persons not involved must be kept at a safe distance from the wirefeed-
er and the welding process
Do not use the functions described here until you have fully read and under-
stood the following documents:
- these operating instructions
- all the operating instructions for the system components, especially the
safety rules
To Next Page
Loading...
Need help?
General
