Why Fronius TPS/i Robotics PushPull CMT power source has no function?
The Fronius Welding System might not be functioning due to several reasons: * A break in the mains lead or the mains plug is not plugged in. Check the mains lead and ensure the plug is properly connected. * A faulty mains socket or plug. In this case, replace the faulty parts. * The mains fuse protection may be triggered. Try changing the mains fuse protection.
What to do if Fronius Welding System has no protective gas shield?
If your Fronius Welding System lacks a protective gas shield, consider these potential causes: * The gas cylinder may be empty, in which case you should change it. * The gas pressure regulator could be faulty, requiring replacement. * The gas hose might be unfitted or damaged; fit or change the hose as needed. * The welding torch may be faulty; consider changing it. * The gas solenoid valve may be faulty. In this case, contact After-Sales Service.
Why Fronius TPS/i Robotics PushPull CMT Welding System has poor weld properties?
Poor weld properties in your Fronius Welding System can stem from several factors: * Incorrect welding parameters: Check the settings. * Poor ground earth connection: Ensure good contact to workpiece. * Inadequate or no protective gas shield: Check the pressure regulator, gas hose, gas solenoid valve, torch gas connection, etc. * Welding torch is leaking: Change the welding torch. * Wrong contact tip, or contact tip is worn out: Replace the contact tip. * Wrong wire alloy or wrong wire diameter: Check the wire electrode that has been inserted and check weldability of the base material. * The shielding gas is not suitable for this wire alloy: Use the correct shielding gas.
What to do if Fronius Welding System has no welding current?
If there is no welding current in your Fronius Welding System, it could be due to: * An incorrect grounding (earthing) connection. Check the grounding connection for correct polarity. * A break in the power cable within the welding torch. Replace the welding torch.
How to fix irregular wire feed speed on Fronius TPS/i Robotics PushPull CMT?
Irregular wire feed speed in your Fronius Welding System could be caused by: * A contact tip hole that's too narrow. Use a suitable contact tip. * A faulty inner liner in the welding torch. Check the inner liner for kinks, dirt, etc. * Feed rollers that aren't suitable for the wire electrode being used. Use suitable feed rollers. * Incorrect contact pressure of the feed rollers. Optimise the contact pressure.
Why Fronius TPS/i Robotics PushPull CMT Welding System welding torch becomes very hot?
A Fronius Welding System torch may overheat due to: * Inadequate welding torch specification. Observe the duty cycle and loading limits. * Inadequate coolant flow (only on water-cooled systems). Check coolant level, coolant flow, and for coolant contamination.
General| Brand | Fronius |
|---|---|
| Model | TPS/i Robotics PushPull CMT |
| Category | Welding System |
| Language | English |
General safety rules, operator duties, and proper device use.
Risks from gases, sparks, electricity, and required personal protective equipment.
Safety precautions for mains, welding current, fire, and gas cylinders.
Steps for fitting the welding system to a conventional robot.
Instructions for inserting rollers, feeding wire, and related safety.
Diagnosing and resolving common welding system malfunctions.
To Next Page