5 Scan
270
Scan
5
1 Press a one touch button. Confirm that the
recipient (e-mail address) specified with the
one touch button is displayed on the touch
screen.
Important • The one touch buttons have a sensor to detect which page of one touch buttons (1 - 18, 19 - 36, or
37 - 54) is currently opened. Before pressing a one touch button, turn over the one touch panel
completely, and take off your hand from the panel. Do not press the button while you are turning
over the panel.
• Do not place any objects near the one touch buttons, nor spill any liquid over them.
Note •Turn the one touch panel over to press the one touch buttons 19 and above.
• If you have entered an incorrect value, select the recipient (e-mail address) displayed on the touch
screen, select [Remove] on the pop-up menu, and enter the correct value.
New Recipient (Entering an Address)
You can enter e-mail addresses using the keyboard.
Note •[Add New Address] is not displayed depending on the settings in the System Administration mode or
depending on the number of registered recipients. Ask your system administrator to confirm the
settings and the number of recipients.
1 Select [New Recipient].
2 Use the keyboard displayed on the screen to
enter an e-mail address with up to 128
characters.
îš„ To/Cc/Bcc
Allows you to switch the recipient type (To/Cc/Bcc) from the drop-down menu.
îš„ + Add
Allows you to add e-mail addresses to send e-mails to multiple recipients (Broadcast).
To Next Page
Loading...
Need help?
General
