2 Product Overview
52
Product Overview
2
Switching the Power On
The following describes how to switch the power on.
To warm up and to be ready to copy or print after switching the power on, the machine takes
approximately 17 seconds when the HDD is not installed, or approximately 24 seconds
when the HDD is installed. This may take more time depending on your machine
configuration.
Switch the power off at the end of the day or when not using the machine for an extended
period of time.
Use also the Energy Saver feature to save power consumption while the machine is not in
use.
For information on the Energy Saver feature, refer to "Energy Saver Mode" (P.57).
Important • If the power is switched off, all the services of the machine will stop. When using the machine
throughout the day for jobs such as receiving fax, do not switch the power off.
1 Press the power switch to the [ | ] position to
switch the power on.
z
When the Finisher B-1 (optional) is installed.
Note •The “Please wait...” message indicates that
the machine is warming up. The machine is
not available during warming up.
• If the machine does not power on, check the
following:
- The power cord is plugged in.
- The main power is switched on.
- The <RESET> button is in the depressed
position.
- The ground fault interrupter is in the ON
position ("|").
To Next Page
Loading...
Need help?
General
