8 Stored Programming
366
Stored Programming
8
- The <Energy Saver> button
z
A stored program registration is canceled when the <Interrupt> button is pressed, the
Auto Clear feature causes a time-out, or a popup window (such as a paper jam window)
appears.
z
If the Fax service is available, one-touch buttons can be used.
Registering Stored Programs for Build Job
Up to 100 actions can be registered with one stored program for Build Job. Up to 40 stored
programs can be registered in the machine.
The following describes how to register actions with stored programs.
1 Select [Store Build Job].
Note •Once a job is stored to a button, it cannot be
overwritten.
• Select [ ] to return to the previous screen or
[ ] to move to the next screen.
2 Select a number to register a stored program.
Note •Once a job is stored to a button, it cannot be overwritten.
• Select [ ] to return to the previous screen or [ ] to move to the next screen.
3 Set the feature you want to register.
Note •The machine sounds an audible tone while a stored program is being registered.
• Press the <Interrupt> button to cancel registration.
You can change the volume of the sound that notifies that a stored program is being registered. For information on the
settings, refer to "5 Tools" > "Common Service Settings" > "Audio Tones" > "Stored Programming Tone" in the Administrator
Guide.
4 Press the <Start> or <Clear All> button.
Note •An icon is displayed to the left of each registered stored program for Build Job.
• If no name is entered for a registered stored program, the name becomes “(No Name)”.
For information on how to name a registered stored program, refer to "Entering/Changing a Stored Program Name" (P.367).
To Next Page
Loading...
Need help?
General
