3 Copy
82
Copy
3
2 Select [Change Quantity].
3 Specify the number of copy sets with the numeric keypad.
The new quantity must include the number of copies that have already been printed. You
cannot enter a number less than the number of copies that have already been printed.
4 Press the <Start> button.
Note •If you enter the same value as the number of copies that have already been printed, the machine
will not execute a copy job even when you press the <Start> button.
Interrupting the Copy Job
You can temporarily stop the copy job to have the machine process another job.
Important • Press the <Interrupt> button only after all the documents have been scanned. The machine does not
accept another job while it is scanning the documents, or [Next Original] has been selected.
1 Press the <Interrupt> button.
The <Interrupt> button lights up to indicate
that the machine is in the Interrupt mode.
2 Load a document and set features if necessary.
3 Specify the number of copy sets with the numeric keypad.
4 Press the <Start> button.
5 After you have finished making the interrupt copy, press the <Interrupt> button.
The <Interrupt> button goes out to indicate that the Interrupt mode is exited.
Note •If you used the document glass to copy the document, remove the document from the document
glass.
6 Press the <Start> button.
The suspended copy job is resumed.
123
456
789
0#
C
To Next Page
Loading...
Need help?
General
