Fax Procedure
163
Fax
4
is used or not in the System Administration mode. For more information, refer to "5 Tools" > "Fax
Service Settings" > "Fax Control" > "Chain Dial" in the Administrator Guide.
For information how to specify a fax number using the Address Book, refer to "Specifying a Destination Using the Address
Book" (P.187).
For information how to specify a fax number using the speed dialing, refer to "Speed Dialing (Specifying a Destination Using
an Address Number)" (P.191).
For information how to specify a fax number using one touch buttons, refer to "Specifying a Destination using a One Touch
Button" (P.195).
For information on the Internet Fax, refer to "About Internet Fax" (P.168).
For information on the IP Fax (SIP), refer to "Internet Fax/Fax/IP Fax (SIP) (Selecting Internet Fax/Fax/IP Fax (SIP))"
(P.186).
Step 4 Starting the Fax Job
The following describes how to start a fax job.
1 Press the <Start> button.
Important • If the document has been loaded in the
document feeder, do not hold down the
document while it is being conveyed.
Note •Depending on the settings, the screen to re-
enter the recipient may be displayed after
pressing the <Start> button. In this case, re-
enter the recipient.
• If a problem occurs, an error message
appears on the touch screen. Solve the
problem according to the message.
îš„ If you have more documents
If you have more documents to fax, select [Next Original] on the touch screen while the
current document is being scanned. This allows you to send the documents as one set of
data.
2 While documents are being scanned, select
[Next Original].
Note •When using the document feeder, load the
next document after the machine has
finished scanning the first document.
• When [Next Original] is displayed on the
screen shown on the right and no operation is
performed during a certain period of time,
the machine automatically assumes that
there are no more documents.
• You can change the scan settings of the next document by selecting [Resolution], [Original Size] and
[Lighten/Darken] that are displayed after selecting [Next Original].
123
456
789
0#
C
To Next Page
Loading...
Need help?
General
