6.5 List of Messages
231
Troubleshooting
6
OpenG.Pull outR4Empty
Punch Cont
Cause: The punch dust box (R4) of the finisher is about to be filled
with punch dust.
Action: Open the finisher front cover (G) and empty the punch dust
box.
“5.5.7 Disposing Chips from Punch Dust Box”(P.150)
Open G.Reload R4Punch
Container
Cause: The punch dust box of the finisher is not correctly set.
Action: Open the finisher front cover (G) and set the punch dust box
correctly.
“3.1 Main Components and Their Functions”(P.30)
Corrupt HD file Press Set key Cause: If the internal hard disk (optional) is installed, data on the
internal hard disk may be destroyed because the power goes
off due to a power failure while the printer is operating.
Action: Press the <Eject/Set> button. Internal hard disk will be initial-
ized.
When the internal hard disk is initialized, registered forms/logos
and secure print data are erased.
xxxx.xxxx
Printing...Tray *
Status: Secure print job is being printed.
Print data can be received from the computer.
xxxx
Printing...Tray**
Note: Report/List is being printed.B
Print data cannot be received from the computer while a report/list
is being printed.
Ended with Error
(***-***)
Cause: An error occurred, and printing was not finished successfully.
Action: Check the error code [***-***] on the display, and take the
appropriate action.
“6.5.2 List of Error Codes2(P.241)
Off-line Status: You pressed the <Online> button and the printer is in the off-
line state. To exit the off-line state, press the <online> button
again.
In the off-line state, print data cannot be received from the com-
puter.
Off-line Data in memory Status: You pressed the <Online> button and the printer is in the off-
line state. To exit the off-line state, press the <online> button
again.
In the off-line state, print data cannot be received from the com-
puter.
Message Cause/action
To Next Page
Loading...
Need help?
General
