6.5 List of Messages
232
Troubleshooting
6
Option not installed Cause: To use the secure/sample print function, the corresponding
optional installation is necessary.
Action: The internal hard disk (optional) must be installed to use the
secure/sample print function.
Please wait... Status:
●
The system status of this printer is being diagnosed/initial-
ized. This message appears during power on or system
resetting. After a while it will change to [Ready to print].
●
Displayed during the warm-up phase before ejecting the
print data that remains in the printer.
Print data cannot be received from the computer.
Close Cover F Cause: Cover F (cover on top of finisher interface) is open.
Action: Close cover F.
“3.1 Main Components and Their Functions”(P.30)
Close Cover L4 Cause: Cover L* is open.
Action: Close cover L*.
“3.1 Main Components and Their Functions”(P.30)
PaperJam-Open L*Lift Green
Lever
Cause: A paper jam has occurred at cover L*.
Action: Check the cover position indicated on the display with the
status display, and remove the jammed paper.
“6.2 Clearing Paper Jams”(P.192)
PaperJam-Open L*Remove
Paper
Cause: A paper jam has occurred at cover L*.
Åyèàíu
Åz
Check the cover position indicated on the display with the
status display, and remove the jammed paper.
“6.2 Clearing Paper Jams”(P.192)
Paper Jam Pull out Tray * Cause: A paper jam has occurred at paper tray *.
Action: Remove the jammed paper from tray *.
“6.2 Clearing Paper Jams”(P.192)
Please wait...
xxxx
Status: The printer is being warmed up phase before ejecting the
print data that remains in the printer.
Print data can be received from the computer.
All data
Cancelling...
Status: The print data that remains in this printer is being discarded.
Print data cannot be received from the computer.
Message Cause/action
To Next Page
Loading...
