6.5 List of Messages
243
Troubleshooting
6
007‑954
[Cause] The paper size loaded in the bypass tray is different from that
specified on the print driver.
[Action] Start printing after specifying the correct paper size on the print
driver.
012‑241
012‑242
012‑244
012‑252
012‑253
[Cause] Failure occurs in the finisher.
[Action] Switch the printer off and on. If the problem still persists, contact
our Customer Support Center.
012‑254
[Cause] The paper ejected to the finisher was taken out before the finisher
tray comes fully down, causing contact with the sensor. Or there
is a foreign object under the finisher tray.
[Action] Switch off the printer, and switch it on again after removing any
foreign object under the finisher tray. If the problem still persists,
contact our Customer Support Center.
012‑255
[Cause] Failure occurs in the finisher.
[Action] Switch the printer off and on. If the problem still persists, contact
our Customer Support Center.
012‑256
012‑257
012‑260
012‑262
012‑267
012‑281
[Cause] Failure occurs in the finisher.
[Action] Switch the printer off and on. If the problem still persists, contact
our Customer Support Center.
016‑503
[Cause] SMTP server name is not set correctly.
[Action] Check if the SMTP server is set up correctly with CentreWare
Internet Services. Also, check the settings for the DNS server.
“4.14.1 Setting up the Environment for E-mail Printing”(P.93)
Error code Cause/action
To Next Page
Loading...
