7.2Description of Common Menu
282
Setting Common Menu
7
Paper Size
Set the paper size to load into the paper tray.
For information about suitable paper sizes, refer to "A Main Specifications" (P.300).
â– Trays 1 to 4
[Auto] (default)
Select when loading paper of standard size.
[Non-Std]
Select [Non-Std] when printing with non-standard paper size, and specify its long edge and short
edge. Specify the edges in mm or inch whichever seleced at Sytem Settings [mm/inch]. The setting
range depends on the unit.
mm: Short edge from 148 to 29 7 mm x Long edge from 210 to 432 mm (PostScript: 140 to 432
mm)
Inch: Short edge from 5.8 to 11.7 inches x Long edge from 8.3 to 17.0 inches
[Tray 2] to [Tray 4] are available when the optional trays are mounted.
Paper Image Qty
You can set image quality according to the paper type: [Plain], [Recycled], [Bond], [Side 2 Paper],
[Heavyweight 1], [Heavyweight 1 S2], [Heavyweight 2], [Heavyweight 2 S2], or [Custom 1] to
[Custom 5]. [User 1] to [User 5] are used to set different image qualities when plain paper is loaded
on more than one tray. Names specified at [Paper Name] are displayed for [User 1] to [User 5].
Set image quality for each type of paper. The optional values are as follows:
â– [Plain], [Recycled], [Plain], [Recycled], [Bond], [Side 2 Paper], Custom 1] to [Custom 5]
A: (Default of [Bond])
Suitable for J paper (82g/m
2
) and other bond paper dedicated to color prints.
B: (Default of [Plain] and [Side 2 Paper])
Suitable for general office paper (P paper, C2, paper, and other).
C: (Default of [Recycled])
Suitable for recycled paper (C2r paper, WR100 paper, and other).
D: Select this for bad paper* subject to quality irregularities during printing.
E: Image quality of [D] with a small number of lines. Select this if quality irregularities are con-
spicuous even in prints by [D]. However, this image quality is available only when [Print Mode]
is set to [Bond] in the properties of the print driver and when [Print Mode] is [Normal], [Quality
Adjustment Mode] is [Recommended], and [Recommended Quality Type] is [Photo] or [Pre-
sentation] at printing.
F: Selet this for bad paper* weighing 90 g/m
2
and subject to quality irregularities during printing.
G: Image quality of [F] with a small number of lines. Select this if quality irregularities are con-
spicuous even in prints by [F]. However, this image quality is available only when [Print Mode]
is set to [Bond] in the properties of the print driver and when [Print Mode] is [Normal], [Quality
Adjustment Mode] is [Recommended], and [Recommended Quality Type] is [Photo] or [Pre-
sentation] at printing.
S: Suitable for paper, plain but heavyweight.
*Bad paper means that you see irreguarities clearly in surface transparency when you hold it against
the sun.
To Next Page
Loading...
Need help?
General
