Fujitsu ETERNUS DX8100 S3 - Page 128

Chapter 3 Component Status
3.7 Controller Module Detail
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
128
The following items are displayed in the Main area:
• Location
The CM number is displayed.
• Status
The CM status is displayed. Refer to "A.5 Component Status" (page 410)
for details.
• Memory Size
The cache memory capacity of the CM is displayed.
• Part Number
The port number of the CM is displayed.
• Serial Number
The serial number of the CM is displayed.
• Hardware Revision
The hardware version of the CM is displayed.
• MAC Address (MNT)
The MAC address of the MNT Port is displayed.
• MAC Address (RMT)
The MAC address of the RMT Port is displayed.
• MAC Address (FST)
The MAC address of the FST Port is displayed.
This item is displayed for the ETERNUS DX500 S3/DX600 S3, the ETERNUS DX8100 S3/DX8700 S3/DX8900
S3, and the ETERNUS AF650.
• Active EC
The Edition Control (EC) number of the currently running firmware is displayed.
• Next EC
The EC number of the firmware that is to be run at the next power-on is displayed.
• CPU#n Clock
The clock frequency of CPU#0 or CPU#1 is displayed.
• CPU#n Status
The status of CPU#0 or CPU#1 is displayed. Refer to "A.5 Component Status" (page 410)
for details.
• CPU#n Status Code
The status code of CPU#0 or CPU#1 is displayed.
• CPU#n Error Code
The error code of CPU#0 or CPU#1 is displayed.
In the Unified Storage environment, " Maintenance" is displayed until a NAS system volume is created.
The CM status changes to " Normal" after a NAS user volume is created and the NAS system volume is
generated.