Fujitsu ETERNUS DX8100 S3 - Thin Provisioning Pools; Thin Provisioning Pool (Basic Information)

Chapter 7 Thin Provisioning Pool Status
7.1 Thin Provisioning Pools
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
325
7.1 Thin Provisioning Pools
The Thin Provisioning Pools category provides the setting information for Thin Provisioning Pools.
7.1.1 Thin Provisioning Pool (Basic Information)
This function shows the list of TPPs.
• When creating TPP type volumes, "Enable" the Thin Provisioning function. Refer to "Set Thin Provisioning"
in "ETERNUS Web GUI User’s Guide (Settings)" for details.
• When the used status of the Thin Provisioning Pool is " Attention" or " Warning" in the TPP list, the
TPP used capacity exceeds the threshold. Add drives immediately to expand the TPP capacity.
• This function displays the TPP basic information, a list of the RAID groups that configure the TPP, and a list
of the TPVs that are registered in the TPP.
• To check whether the Thin Provisioning function is enabled or disabled, refer to "7.3 Settings (Thin
Provisioning)" (page 355).
• To check the threshold for monitoring the used capacity of a TPP, refer to "7.1.5 Threshold (Thin
Provisioning Pool)" (page 334).
• To check the Eco-mode settings of a TPP, refer to "7.1.6 Eco-mode Schedule (Thin Provisioning Pool)"
(page 337).