Fujitsu ETERNUS DX8100 S3 - Performance (CM)

Chapter 3 Component Status
3.2 Controller Enclosure
ETERNUS Web GUI User’s Guide (Operation)
Copyright 2016 FUJITSU LIMITED P2X0-1260-19ENZ0
83
• Status
The CM status is displayed. Refer to "A.5 Component Status" (page 410)
for details.
3.2.2 Performance (CM)
The CM performance information is displayed.
■ For the ETERNUS DX8700 S3/DX8900 S3
• Performance information is obtained when performance monitoring is operated from ETERNUS Web GUI,
ETERNUS CLI, or any other monitoring software. Refer to "Start/Stop Performance Monitoring" in "ETERNUS
Web GUI User’s Guide (Settings)" for details on how to start performance monitoring with ETERNUS Web
GUI.
• The interval for acquiring performance information can be specified when starting the monitoring. When
using ETERNUS Web GUI, the default interval is 30 seconds.
• The average performance values during the specified interval are displayed.